DP/Pro Hall
The DP/Pro Hall is a plugin created by MikeAudet Mike Audet for the PARIS EDS effects system.
According to Mike, "This is the reverb I've been waiting for since the Skunkworks team began. It's smooth, wide, and you can run 4 of them on an EDS card. It is the best reverb I have ever worked with.
You can check out a demo here."
Installing the DP/Pro Hall (.pdf)
Controls explained:
Decay:
Controls the amount of time for the reverb to decay
Low Decay:
Acts as a tone control and will boost (positive values) or cut (negative values) the rate at which low frequencies decay
Damping:
Controls the attenuation of high frequencies in the decay of the reverb
High BW:
A low-pass filter on the signal going into the reverb
Diffuser 1:
Smears the input signal transients
Diffuser 2:
Smears the input signal transients at lower frequencies than Diffuser 1
Definition:
Controls the rate at which echo density is increased with time
Detune Rate:
Controls the LFO rate of detuning introduced into the reverb decay
Detune Depth:
Controls the depth of the detuning
Primary Send:
Controls the level of the diffused input signal into reverb definition
Ref 1 - 2 Level:
Controls the level of the first/second pre-echo
Ref 1 - 2 Send:
Controls the level of the first/second pre-echo sent directly to the output
Ref 1 - 2 L/R:
These four controls control the right and left delay time of the first and second pre-echoes
Out Balance:
Pans the reverb's output
Predelay:
Adjusts the time it takes for the original signal to reach the reverb
Position 1 - 3:
Controls the levels of a mic placed in front, in the middle, and at the rear of the hall.
Bugs/peculiarities:
Suggested Applications and Settings:
