Revision [1251]

This is an old revision of MixerLess made by admin on 2009-07-06 11:24:05.

 

Live Monitor and Record at the Same Time


(originally contributed by Brian Tankersley)

One of PARIS' great strengths is its extraordinarily low inherent latency. Because of this, properly configured PARIS rig can minimize the need for an external patchbay.

Live Monitor and Record at the Same Time:

  1. Step A. Set all the *TOP* EDS inserts on your Paris ppj template to
External. Then put all of the individual External inserts in Bypass. You
should save the ppj that way. This assumes you don't use 4 EDS inserts
at once.

  1. Step B. Whatever your Input source is to a given channel of the Paris
Mixer, in the Patchbay, patch it to both the Mixer and also to the
Insert Return (top row) of the Insert Block. So any Input patch goes to
the both the Mixer in and the Insert return of the same channel. i.e.,
MEC Input 1 goes to Mixer Input 1 *and* Insert 1 Return (top row).

  1. You (unfortunately) must complete the Insert loop by connecting
each Insert Send (bottom row) to another point. If you don't use
external FX returns, you could just patch all 16 Insert Sends to the FX
Returns (top row). Or use some of the MEC Master patch points. Or some
other combo that works for you.

  1. Save this as your default ppj [and/or as a Patchbay setup] and you're
good.

When you want Live input without Record Enable, just pop on the
External EDS insert on any channel. You'll get the input, complete with
any other EDS inserts, EQ, FX sends....the whole enchilada just like you
were in Record Ready and Always Monitor Input. If you want to hear
what's already been recorded on that channel as is normal for Paris,
just bypass the External EDS insert.

Regards,
Brian T

There are no comments on this page.
Valid XHTML :: Valid CSS: :: Powered by WikkaWiki